VARIABLE TUMBLE SOLENOID VALVE INSPECTION[LF, L3]


id0113b3802900

1.  Remove the variable tumble solenoid valve. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION[LF, L3].)

2.  Inspect airflow between the ports under the following conditions.

•  If not as specified, replace the variable tumble solenoid valve. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION[LF, L3].)
•  If as specified, carry out the “Circuit Open/Short Inspection”.
am3zzw00000119

LF

am3zzw00000120

L3

am3zzw00003209


Circuit Open/Short Inspection

1.  Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION[LF, L3].)

2.  Inspect the following wiring harness for open or short (continuity check).

am3zzw00000121
am3zzw00002510
am3zzw00001811


Open circuit

•  If there is no continuity, the circuit is open. Repair or replace the wiring harness.
―  Variable tumble solenoid valve terminal A and main relay terminal A
―  Variable tumble solenoid valve terminal B and PCM terminal 2I*1, 2AI*2


Short circuit

•  If there is continuity, the circuit is shorted. Repair or replace the wiring harness.
―  Variable tumble solenoid valve terminal A and body ground
―  Variable tumble solenoid valve terminal B and power supply
―  Variable tumble solenoid valve terminal B and body ground
*1  :MTX, LF ATX (FS5A-EL)
*2  :LF ATX (FN4A-EL), L3 ATX