CRASH ZONE SENSOR REMOVAL/INSTALLATION
id081000800500
1. Place alignment marks on the bonnet latch and shroud panel.
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove in the order indicated in the table.
am3zzw00001089
|
1
|
Bolt
|
2
|
Cover
|
3
|
Connector
|
4
|
Crash zone sensor
|
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position.
7. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
Crash Zone Sensor Installation Note
1. Align the alignment marks on the bonnet latch and shroud panel made prior to removal, and install the crash zone sensor.
2. Refer to “BONNET ADJUSTMENT” and verify that the gap and height difference between the bonnet and body are within the specifications. Adjust the bonnet if necessary. (See BONNET ADJUSTMENT)