REAR BUMPER REMOVAL/INSTALLATION

id091000800700

1.  Disconnect the negative battery cable.

2.  Remove the trunk end trim. (SeeTRUNK END TRIM REMOVAL/INSTALLATION.)

3.  Remove the fasteners and slightly bend back the trunk side trim. (RH)

4.  Remove the fasteners and slightly bend back the trunk side trim. (LH) (4SD)

5.  Remove the service hole cover. (LH) (5HB)

6.  Remove the rear combination light. (SeeREAR COMBINATION LIGHT REMOVAL/INSTALLATION.)

7.  Disconnect the license plate light connector.

am3zzw00002222

8.  Remove in the order indicated in the table.

am3zzw00002223

1	Screw A
2	Fastener A
3	Rear flap
4	Fastener B
5	Fastener C
6	Screw B
7	Screw C
8	Rear bumper (SeeRear Bumper Removal Note.) (SeeRear bumper Installation Note.)

9.  Install in the reverse order of removal.

Rear Bumper Removal Note

1.  Pull the rear bumper ends (wheel arch) outward to detach from the bumper slider.

Caution

•  When detaching the rear bumper from the bumper slider, the rear bumper could fall and be damaged. Secure the rear bumper so that it does not fall.

am3zzw00002224

Rear bumper Installation Note

1.  Spread the rear bumper ends (wheel arches) apart.

2.  Attach the rear bumper to the body.

3.  Press the rear bumper connecting area into the body to engage with the bumper slider.