INSTRUMENT CLUSTER INSPECTION

id092200800400


Speedometer


Using the input/output check mode

1.  Inspect the speedometer by setting it to check code 12 of the input/output check mode. (See INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE.)


Using a speedometer tester

1.  Adjust the tire pressure to the specification.

2.  Using a speedometer tester, verify that the tester reading is as indicated in the table below.

Speedometer tester indication (km/h)

Allowable range (km/h)

Except L3 Turbo

L3 Turbo

Australisan, European (L.H.D.) specs.

General (L.H.D. R.H.D.) specs.
20
20—25
17—23
20—26
40
40—45
38—43
41—47
60
60—66
57—63
61—68
80
81—87
77—83
82—89
100
101—108
97—103
102—110
120
121—129
116—124
123—131
140
142—149
136—144
144—152

U.K. specs.

Speedometer tester indication (mph)

Allowable range (mph)

Except L3 Turbo

L3 Turbo
10
10—14
10—14
20
20—23
20—24
30
30—34
30—35
40
40—44
41—45
50
50—55
51—56
60
60—65
61—67
70
70—76
72—77
80
81—86
82—88

3.  Verify that the speedometer reading is within the range indicated in the table.

•  If the speedometer does not move or the indication is not within the allowable range, inspect the PCM and related wiring harnesses.
―  If the PCM and related wiring harnesses are normal, replace the instrument cluster.


Tachometer


Using the input/output check mode

1.  Inspect the tachometer by setting it to check code 13 of the input/output check mode. (See INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE.)


Using M-MDS or external diagnostic equipment

Caution
•  If the engine speed exceeds the allowable range, the engine could be damaged. Therefore, when inspecting the tachometer, do not allow the engine speed to exceed the allowable range indication on the tachometer.

1.  Connect the M-MDS to the DLC-2.

am3zzw00001959

2.  Compare the data monitor item (RPM) with the tachometer indication.

•  If the tachometer does not operate properly, inspect the PCM and related wiring harnesses.
―  If the PCM and related harnesses do not have any malfunction, replace the instrument cluster.


Fuel gauge

1.  Inspect the fuel gauge by setting it to check code 23 of the input/output check mode. (See INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE.)


Water temperature gauge

1.  Inspect the water temperature gauge by setting it to check code 25 of the input/output check mode. (See INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE.)