i-stop WARNING LIGHT (AMBER) [SKYACTIV-D 1.5]

id0140z5008700

Purpose, Function

• If the i-stop control inhibits the operation, the i-stop warning light (amber) flashes/illuminates to inform the driver that the i-stop control inhibits the operation.

Construction

• The i-stop warning light (amber) is equipped in the instrument cluster.

am3zzn00006116

• For vehicles with center display, a warning message in the center display is displayed when the i-stop warning light (amber) is illuminated or flashes. For the message content and verification method, refer to the “CENTER DISPLAY”. (See CENTER DISPLAY [WITH CENTER DISPLAY].)

Operation

• The flashing/illumination conditions of the i-stop warning light (amber) are as follows:

i-stop warning light (amber) flashing condition

― Any of the following DTCs are stored:

PCM DTC

• P0555:00, P057F:00, P058A:00, P0615:00, P0A0F:00, P0A8D:00, P0A8F:00, P0A94:00, P2502:00, P2503:00, P2504:00, U0101:00, U0121:00, U0131:00, U0140:00, U0151:00, U0155:00, U0214:00, U0298:00

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM TEST MODE”. (See ON-BOARD DIAGNOSTIC SYSTEM TEST MODE [PCM (SKYACTIV-D 1.5)].)

TCM DTC

• P0C2C:00, P0C2D:00, P181F:00, P2712:00

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM MALFUNCTION DETECTION FUNCTION”. (See ON-BOARD DIAGNOSTIC SYSTEM MALFUNCTION DETECTION FUNCTION [TCM (EW6A-EL)].)

DSC HU/CM DTC

• C0001:01, C0002:01, C0003:01, C0004:01, C0010:01, C0011:01, C0014:01, C0015:01, C0018:01, C0019:01, C001C:01, C001D:01, C0031:11, C0031:64, C0034:11, C0034:64, C0037:11, C0037:64, C003A:11, C003A:64, C0040:64, C0044:28, C0044:54, C0062:28, C0062:54, C0062:64, U0001:88, U0100:00, U0101:00, U0151:00, U0155:00, U0401:00, U0402:00, U2300:54, U2300:55, U2300:56, U2300:64, U3000:49, U3003:16, U3003:17

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM”. (See ON-BOARD DIAGNOSTIC SYSTEM [DYNAMIC STABILITY CONTROL (DSC)].)

EPS control module DTC

• C200B:62, U0001:88, U0121:00, U0415:00, U3000:28, U3000:41, U3000:47, U3000:49, U3000:61, U3000:96

• For details on DTCs, refer to “ON-BOARD DIAGNOSTIC SYSTEM”. (See ON-BOARD DIAGNOSTIC SYSTEM [ELECTRIC POWER STEERING (EPS)].)

i-stop warning light (amber) illumination condition

― Any one of the following conditions is met:

• Ignition switched ON (check of i-stop control system)

• i-stop OFF switch is on

• Engine stalls due to driver's operation while engine is stopped by i-stop control

• Communication error to PCM and instrument cluster

• The PCM sends an i-stop warning light (amber) flashing/illumination request to the instrument cluster via CAN communication.