DTC P0607:00 [MZR-CD 2.2]

id0102f3850500

DTC P0607:00

PCM performance malfunction

DETECTION CONDITION

•  PCM internal malfunction.

Diagnostic support note

•  The MIL does not illuminate.

•  The DTC is stored in the PCM memory.

POSSIBLE CAUSE

•  PCM internal malfunction

DTC P0607:00	PCM performance malfunction
DETECTION CONDITION	• PCM internal malfunction. Diagnostic support note • The MIL does not illuminate. • The DTC is stored in the PCM memory.
POSSIBLE CAUSE	• PCM internal malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA (MODE2) OR SNAPSHOT DATA HAVE BEEN RECORDED • Have FREEZE FRAME DATA (mode2) or snapshot data been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA (mode2) and snapshot data on repair order, then go to the next step.
2	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING OF P0607:00 COMPLETED • Make sure to reconnect all disconnected connectors. • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [MZR-CD 2.2].) • Start the engine. • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [MZR-CD 2.2].) • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [MZR-CD 2.2].)
3		No	Go to the next step.
4	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [MZR-CD 2.2].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR-CD 2.2].)
4		No	DTC troubleshooting completed.