DTC P061F:00 [MZR 2.0, MZR 2.5]

id0102g3302600

DTC P061F:00

Internal control module throttle valve actuator controller performance problem

DETECTION CONDITION

•  Indicates that a calculation error occurred in the PCM.

Diagnostic support note

•  This is a continuous monitor (other).

•  The MIL does not illuminate.

•  FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.

•  The DTC is stored in PCM memory.

POSSIBLE CAUSE

Note

•  This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first.

•  PCM connector or terminals malfunction

•  PCM malfunction

DTC P061F:00	Internal control module throttle valve actuator controller performance problem
DETECTION CONDITION	• Indicates that a calculation error occurred in the PCM. Diagnostic support note • This is a continuous monitor (other). • The MIL does not illuminate. • FREEZE FRAME DATA (Mode 2)/Snapshot data is not available. • The DTC is stored in PCM memory.
POSSIBLE CAUSE	Note • This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first. • PCM connector or terminals malfunction • PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY RELATED SERVICE INFORMATION AVAILABILITY • Verify related Service Information availability. • Is any related Service Information available?	Yes	Perform repair or diagnosis according to the available Service Information. • If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	VERIFY RELATED PENDING CODE AND STORED DTC • Switch the ignition to off, then to ON (engine off). • Perform the DTC Reading Procedure and Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0, MZR 2.5].) • Are any other DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR 2.0, MZR 2.5].)
2		No	Go to the next step.
3	INSPECT PCM CONNECTOR CONDITION • Switch the ignition to off. • Disconnect the PCM connector. • Inspect for poor connection (such as damaged/pulled-out pins, corrosion). • Is there any malfunction?	Yes	Repair or replace the terminal and/or connector, then go to the next step.
3		No	Connect the PCM connector and verify that the connector seat correctly, then go to the next step.
4	VERIFY DTC TROUBLESHOOTING COMPLETED • Make sure to reconnect all disconnected connectors. • Clear the DTC from the PCM memory using the M-MDS. (See AFTER REPAIR PROCEDURE [MZR 2.0, MZR 2.5].) • Perform the KOEO or KOER self test. (See KOEO/KOER SELF TEST [MZR 2.0, MZR 2.5].) • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)
4		No	Go to the next step.
5	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [MZR 2.0, MZR 2.5].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR 2.0, MZR 2.5].)
5		No	DTC troubleshooting completed.