FUEL FILTER (HIGH-PRESSURE) REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6]

id0114as803000

Warning

• Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to “BEFORE SERVICE PRECAUTION”.

• A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make sure to discharge static electricity by touching the vehicle body.

Caution

• Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.

Fuel Filter (High-pressure) Is a Built-in Type In Fuel Pump Unit

1. Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [MZR 1.5, MZR 1.6].)

2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

4. Remove the rear seat cushion. (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

5. Remove the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

6. Remove the fuel filter (high-pressure). (See FUEL PUMP UNIT DISASSEMBLY/ASSEMBLY [MZR 1.5, MZR 1.6].)

7. Install in the reverse order of removal.

8. Complete the “AFTER SERVICE PRECAUTION”. (See AFTER SERVICE PRECAUTION [MZR 1.5, MZR 1.6].)

Fuel Filter (High-pressure) Is Not a Built-in Type In Fuel Pump Unit

1. Complete the “BEFORE SERVICE PRECAUTION”. (See BEFORE SERVICE PRECAUTION [MZR 1.5, MZR 1.6].)

2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

4. Remove the under cover. (See REAR TRAILING LINK REMOVAL/INSTALLATION.)

5. Remove in the order indicated in the table.

am3zzw00012044

1

Quick release connector

(See QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

2

Fuel filter (high-pressure)

6. Install in the reverse order of removal.

7. Complete the “AFTER SERVICE PRECAUTION”. (See AFTER SERVICE PRECAUTION [MZR 1.5, MZR 1.6].)

1	Quick release connector (See QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)
2	Fuel filter (high-pressure)