PURGE SOLENOID VALVE INSPECTION [MZR 2.0, MZR 2.5]


id0116f9800900


Airflow inspection

1.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

2.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

3.  Remove the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

4.  Inspect airflow between the ports under the following conditions.

am3zzw00012156

Measured condition

Continuity between A—B

When voltage is not applied between terminals A and B
No airflow
When voltage is applied between terminals A and B
Airflow detected

•  If not as specified, replace the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)