PURGE SOLENOID VALVE INSPECTION [SKYACTIV-G 2.0]

id0116z8800900

Airflow Inspection

1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

3. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

4. Inspect airflow between the ports under the following conditions.

am3uuw00007299

Measured condition

The airflow state between port A—B

When voltage is not applied between terminals A and B

No airflow

When voltage is applied between terminals A and B

Airflow detected

Measured condition	The airflow state between port A—B
When voltage is not applied between terminals A and B	No airflow
When voltage is applied between terminals A and B	Airflow detected

• If not as specified, replace the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)