CRUISE CONTROL SWITCH INSPECTION [MZR 1.6]

id0120e4800100

1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

2. Disconnect the negative battery cable and wait for 1 min or more. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5, MZR 1.6].)

3. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)

4. Disconnect the clock spring connector (part wiring harness-side).

5. Measure the resistance between clock spring terminals K and M (part wiring harness-side) using a tester.

am3zzw00011548

• If as specified, go to the next step.

• If not as specified, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)

Switch condition

Resistance (ohm)

Cruise OFF switch held at on

Continuity

CANCEL switch held at on

Approx. 120

SET (−) switch held at on

Approx. 300

SET (+) switch held at on

Approx. 600

RESUME switch held at on

Approx. 1,110

Cruise ON switch held at on

Approx. 2,110

Neutral

Approx. 4,310

Switch condition	Resistance (ohm)
Cruise OFF switch held at on	Continuity
CANCEL switch held at on	Approx. 120
SET (−) switch held at on	Approx. 300
SET (+) switch held at on	Approx. 600
RESUME switch held at on	Approx. 1,110
Cruise ON switch held at on	Approx. 2,110
Neutral	Approx. 4,310

6. Apply battery positive voltage to clock spring terminal O (part wiring harness-side), and terminal E (part wiring harness-side) to ground.

am3zzw00011549

7. Verify that the LED illuminates.

• If the LED does not illuminate, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)