BAROMETRIC PRESSURE (BARO) SENSOR INSPECTION [MZR 2.0, MZR 2.5]

id0140e4801100

Voltage Inspection

Note

•  Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM.

1.  Connect the M-MDS to the DLC-2.

am3zzw00011819

2.  Switch the ignition to ON.

3.  Verify that the BARO sensor output voltage (PID: BARO) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.0, MZR 2.5].) (See PCM INSPECTION [MZR 2.0, MZR 2.5].)

•  If not as specified, replace the PCM. (See PCM REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)