CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [MZR 2.0, MZR 2.5]

id0140e4801600

Continuity Inspection

1.  Verify that the CPP switch is installed properly. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)

2.  Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

3.  Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5].)

4.  Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)

5.  Verify that the continuity between CPP switch terminals A and B when the clutch pedal is depressed and when it is released is according to the following table:

am3zzw00011821

•  If not as verified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)