DTC U0300:00


id020200801600

DESCRIPTION

Incomplete configuration

DETECTION CONDITION
•  TPMS tire identifier is a repetition error.
POSSIBLE CAUSE
•  Wheel unit malfunction
―  ID registration procedure has not been performed properly.
•  Instrument cluster malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1
VERIFY PROGRAMMED ID OF WHEEL UNIT
•  Switch the ignition to off.
•  Connect the M-MDS to the DLC-2.
•  Select the following PIDs using the M-MDS:
―  WU1_ID
―  WU2_ID
―  WU3_ID
―  WU4_ID
•  Switch the ignition to ON.
•  Is the same code in the output ID?
Yes
Configure the instrument cluster, then go to the next step.
No
Go to the next step.
2
VERIFY TROUBLESHOOTING COMPLETED
•  Clear the DTC from the instrument cluster memory using the M-MDS.
•  Drive the vehicle at speed of 25 km/h {16 mph} or more for 10 min or more.
•  Retrieve the TPMS DTC using the M-MDS.
•  Is the same DTC present?
Yes
Replace the instrument cluster, then go to the next step.
No
Go to the next step.
3
VERIFY THAT NO OTHER DTCs ARE PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
No
DTC troubleshooting completed.