DTC INSPECTION [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)]

id0902g8440500

Note

•  All DTCs displayed in the DTC inspection should be entered in the Audio Repair Order Form.

Using the M-MDS

1.  Connect the M-MDS (IDS) to the DLC-2.

am3uuw00003108

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “ACU”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the Bluetooth unit. (See CLEARING DTC [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)].)

Without Using M-MDS (On-board Diagnostic Test Mode)

1.  Switch the ignition to ACC or ON.

2.  While pressing the POWER/VOLUME switch, simultaneously press the PRESET switch 1 and the PRESET switch 6 for 3 s or more.

With RDS (radio data system)

am3uuw00003109

Without RDS (radio data system)

am3zzw00007432

Note

•  If several DTCs are in the memory, they can be displayed using the SEEK/TRACK switch (up or down).

amxzzw00001109

3.  To stop the on-board diagnostic test mode, ignition is switched to off.