CLEARING DTC [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)]

id0902g8855600

Caution

•  Before clearing the DTCs, be sure to enter all of the DTCs displayed in the DTC inspection in the Audio Repair Order Form.

Using the M-MDS

1.  Connect the M-MDS (IDS) to the DLC-2.

am3uuw00003028

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

1.  Select “Self Test”.

2.  Select “Modules”.

3.  Select “ACU”.

3.  Verify the DTC according to the directions on the screen.

4.  Press the clear button on the DTC screen to clear the DTC.

5.  Switch the ignition to off.

6.  Switch the ignition to ON and wait for 5 s or more.

7.  Perform DTC inspection. (See DTC INSPECTION [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)].)

8.  Verify that no DTCs are displayed.

Without Using M-MDS (On-board Diagnostic Test Mode)

1.  Launch the on-board diagnostic test mode. (See DTC INSPECTION [Bluetooth SYSTEM (HANDS-FREE TELEPHONE (HF/TEL) SYSTEM)].)

2.  While pressing the AUTO-M switch, simultaneously press the PRESET switch 4 for 3 s or more.

Note

•  The AUTO-M function operates when the AUTO-M switch is pressed, however, press and hold it until the audio amplifier control condition inspection launches.

With RDS (radio data system)

am3zzw00007433

Without RDS (radio data system)

am3zzw00007434

3.  To stop the on-board diagnostic test mode, ignition is switched to off.