DTC P0219:00 [MZR-CD 2.2]
id0102f3148300
|
DTC P0219:00 |
Engine overspeed condition |
|---|---|
|
DETECTION CONDITION
|
• The PCM monitors the engine speed. If the engine speed is 5,300 rpm or more, the PCM determines that there is a malfunction in the control system.
Diagnostic support note
• The MIL does not illuminate.
• FREEZE FRAME DATA (Mode 2)/Snapshot data is not available.
• The DTC is not stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Inadequate engine compression due to engine internal malfunction
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT ENGINE COMPRESSION
• Inspect the engine compression.
• Is there any malfunction?
|
Yes
|
Overhaul the engine for repairs, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Start the engine.
• Perform the DTC Reading Procedure.
• Is the same DTC present?
|
Yes
|
Replace the PCM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [MZR-CD 2.2].)
|
|
No
|
DTC troubleshooting completed.
|
||