HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5]
id0140d7804000
MZR 1.8, MZR 2.0
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].)
2. Remove the floor under cover. (If equipped) (See FLOOR UNDER COVER REMOVAL/INSTALLATION.)
3. Disconnect the HO2S connector.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
am6zzw00005192
|
1
|
Wiring harness bracket
|
2
|
HO2S
|
Wiring harness bracket installation note
am6zzw00005193
|
MZR 2.5
1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].)
2. Remove the floor under cover. (If equipped) (See FLOOR UNDER COVER REMOVAL/INSTALLATION.)
3. Disconnect the HO2S connector.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
am6zzw00005194
|
1
|
Wiring harness bracket
|
2
|
HO2S
(See HO2S removal note.)
|
HO2S removal note
1. For easier access, remove the three-way catalytic converter (TWC) from the hanger rubber on the vehicle side.
2. Remove the HO2S using the SST.
Wiring harness bracket installation note
am6zzw00005195
|