EXHAUST GAS TEMPERATURE SENSOR INSPECTION [MZR-CD 2.2]


id0140f2446300

Warning
•  When the engine and exhaust system are hot, they can cause severe burns or injury. Turn off the engine and wait until they are cool before removing the exhaust system.
Caution
•  Perform exhaust gas temperature sensor removal/installation only when inspection or replacement is required, such as when DTCs for the sensor are displayed, because it may cause exhaust gas leaks. If removal or installation/removal is performed, always verify that there is no exhaust gas leak after reinstallation.
Note
•  Perform the following test only when directed.

Resistance Inspection

1.  Remove the exhaust gas temperature sensor. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR-CD 2.2].)

2.  Place the Exhaust gas temperature sensor in water with a thermometer, and heat the water gradually.

3.  Measure the resistance between the Exhaust gas temperature sensor terminals using an ohmmeter.

•  If not as specified, replace the Exhaust gas temperature sensor. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR-CD 2.2].)

Specification

Water temperature (°C {°F})

Resistance (kilohm)

50 {122}
82—137

am6zzw00004017