NO.6 DSC INDICATOR LIGHT FLASHES (WHEN NEITHER THE TCS NOR THE DSC ARE OPERATING) [DYNAMIC STABILITY CONTROL (DSC)]

id0403b2880300

6

DSC indicator light flashes (when neither the TCS nor the DSC are operating)

POSSIBLE CAUSE

• Non-completion of module configuration (If the module configuration is not carried out after replacing the DSC HU/CM, a DSC indicator light will flash. In this case, the DSC is not detected.)

6	DSC indicator light flashes (when neither the TCS nor the DSC are operating)
POSSIBLE CAUSE	• Non-completion of module configuration (If the module configuration is not carried out after replacing the DSC HU/CM, a DSC indicator light will flash. In this case, the DSC is not detected.)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	INSPECT CONNECTION OF DSC HU/CM, SAS CONTROL MODULE AND STEERING ANGLE SENSOR CONNECTORS • Inspect for connection of DSC HU/CM, SAS control module (yaw rate sensor, low-G (XY) sensor) and steering angle sensor connectors. • Are DSC HU/CM, SAS control module and steering angle sensor connectors connected securely?	Yes	Perform the initialization procedure. (See DSC CONFIGURATION.) (See DSC SENSOR INITIALIZATION PROCEDURE.)
1		No	Perform the initialization procedure after connect the suspected connector securely. (See DSC CONFIGURATION.) (See DSC SENSOR INITIALIZATION PROCEDURE.)