BRAKE PEDAL INSPECTION

id041100801100

Brake Pedal Height Inspection

1. Measure the distance from the steering shaft cover installation surface to the center of the upper surface of the pedal pad as shown in the figure and verify that it is as specified.

L.H.D.

am6zzw00005042

R.H.D.

am6zzw00005043

Brake pedal height (reference value)

L.H.D.: 170 mm {6.69 in}

R.H.D.: 181 mm {7.13 in}

Brake Pedal Height Adjustment

Caution

• The brake switch may not operate normally after adjusting the pedal height. Whenever adjusting the pedal height, replace the brake switch with a new one.

1. Loosen locknut and turn fork to adjust the height.

am6zzw00005044

2. Tighten the locknut.

Tightening torque

21—30 N·m {2.2—3.0 kgf·m, 16—22 ft·lbf}

3. After adjustment, inspect the pedal play and the brake light operation.

Brake Pedal Play Inspection

1. Depress the pedal a few times to eliminate the vacuum in the system.

2. Remove the spring pin, verify that the holes in the fork and in the pedal are aligned, and reinstall the pin. (See BRAKE PEDAL REMOVAL/INSTALLATION.)

3. Gently depress the pedal by hand until resistance is felt, and check the pedal play.

Brake pedal play

4—8 mm {0.2—0.3 in}

Pedal-to-floor Clearance Inspection

1. Start the engine and depress the brake pedal with a force of 147 N {15.0 kgf, 33.0 lbf}

2. Verify that the distance from the floor panel to the pedal pad center is as specified when the pedal is depressed.

• If the distance is less than specified, check for air in brake system.

Brake pedal-to-floor clearance (Brake pedal when depressed at 147 N {15.0 kgf, 33.0 lbf})

95 mm {3.7 in}

L.H.D.

am6zzw00005045

R.H.D.

am6zzw00005046