BACK-UP LIGHT SWITCH REMOVAL/INSTALLATION [G66M-R]

id0515k1800800

2. Remove the battery and battery tray. (MZR 2.0, MZR 2.5)(See BATTERY REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].)

3. Remove the battery component. (ex: battery, battery tray and PCM component)(MZR 2.0 DISI)(See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI].)

4. Remove the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

5. Drain the oil from the transaxle. (See TRANSAXLE OIL REPLACEMENT [G66M-R].)

6. Disconnect the back-up light switch connector and remove the back-up light switch.

am3uuw00002140

7. Install the back-up light switch (with a new gasket) to the transaxle case.

Tightening torque

20—29 N·m {2.1—2.9 kgf·m, 15—21 ft·lbf}

8. Connect the back-up light switch connector.

9. Add the specified amount and type of oil. (See TRANSAXLE OIL REPLACEMENT [G66M-R].)

10. Install the aerodynamic under cover No.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

11. Install the battery and battery tray. (MZR 2.0, MZR 2.5)(See BATTERY REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].)

12. Install the battery component. (ex: battery, battery tray and PCM component)(MZR 2.0 DISI)(See BATTERY REMOVAL/INSTALLATION [MZR 2.0 DISI].)