TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT [FS5A-EL]

id051721803700

Caution

•  Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1.  Select the selector lever to N position.

2.  Engage the parking brake and use wheel chocks at the front and rear of the wheels.

3.  Perform the following procedures.

(1)  Disconnect the negative battery cable.

(2)  Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 1.8, MZR 2.0, MZR 2.5].) (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.0 DISI].)

(3)  Disconnect the TR switch connector.

am6zzw00006793

4.  Loosen the TR switch.

(1)  Remove the aerodynamic under cover NO.2. (See AERODYNAMIC UNDER COVER NO.2 REMOVAL/INSTALLATION.)

(2)  Remove the clip from the selector cable.

(3)  Disconnect the selector cable from manual shaft lever.

am6zzw00005412

(4)  Loosen the TR switch installation bolts.

am6zzw00005413

5.  Adjust the TR switch.

(1)  Verify that the manual shaft is aligned with N position.

am6zzw00004871

(2)  Adjust the TR switch between terminals B and C until the resistance becomes specification.

am6zzw00005414

TR switch specification

713—787 ohms

(3)  Tighten the TR switch installation bolts.

Tightening torque

8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}