DTC B10FD:55/B10FE:55

id080200822700

System Malfunction Location

DTC	System Malfunction Location
M-MDS display
B10FD:55	Configuration setting error (driver-side side air bag sensor No.1 structural malfunction)
B10FE:55	Configuration setting error (passenger-side side air bag sensor No.1 structural malfunction)

Detection Condition

Warning

•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.

Possible Causes

Diagnostic Procedure

Step	Inspection		Action
1	PERFORM SAS CONTROL MODULE INSPECTION •  Perform the configuration for the SAS control module using the M-MDS. (See SAS CONTROL MODULE CONFIGURATION.) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC DISPLAY.) •  Are the same DTCs present?	Yes	Perform the SAS control module configuration, then go to the next step. (See SAS CONTROL MODULE CONFIGURATION.)
		No	DTC troubleshooting completed.
2	INSPECT DRIVER AND PASSENGER-SIDE SIDE AIR BAG SENSOR NO.1 •  Switch the ignition to off. •  Disconnect the negative battery cable and wait for 1 min or more. •  Disconnect the driver and passenger-side side air bag sensor No.1 connector. •  Connect the negative battery cable. •  Switch the ignition to ON. •  Clear the DTC for the SAS control module using the M-MDS. (See CLEARING DTC.) •  Perform the DTC inspection for the SAS control module using the M-MDS. (See DTC DISPLAY.) •  Are the same DTCs present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
		No	DTC troubleshooting completed.