DTC B1D75:55


id080200828000


System Malfunction Location

•  Configuration setting error (PAD switch structural malfunction)

Detection Condition

Warning
•  Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
•  SAS control module configuration setting has not been done correctly

Possible Causes

•  SAS control module configuration setting not implemented
•  SAS control module configuration setting invalid
•  PAD switch assembly incorrect
•  SAS control module malfunction

Diagnostic Procedure

Step

Inspection

Action

1
PERFORM SAS CONTROL MODULE INSPECTION
•  Perform the configuration for the SAS control module using the M-MDS.
•  Perform the DTC inspection for the SAS control module using the M-MDS.
•  Are the same DTCs present?
Yes
Perform the SAS control module configuration, then go to the next step.
No
DTC troubleshooting completed.
2
INSPECT PAD SWITCH
•  Switch the ignition to off.
•  Disconnect the negative battery cable and wait for 1 min or more.
•  Disconnect the PAD switch connector.
•  Connect the negative battery cable.
•  Switch the ignition to ON.
•  Clear the DTC for the SAS control module using the M-MDS.
•  Perform the DTC inspection for the SAS control module using the M-MDS.
•  Are the same DTCs present?
Yes
Replace the SAS control module.
No
DTC troubleshooting completed.