DTC INSPECTION [AUDIO]

id0902f6440500

Note

•  All DTCs displayed in the DTC inspection should be entered in the Audio Repair Order Form.

With M-MDS

1.  Connect the M-MDS(IDS) to the DLC-2.

am6zzw00006237

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

(1)  Select “Self Test”.

(2)  Select “Modules”.

(3)  Select “ACU”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.

4.  After completion of repairs, clear all DTCs stored in the audio unit. (See CLEARING DTC [AUDIO].)

Without M-MDS (On-board Diagnostic Test Mode)

1.  Switch the ignition to ACC or ON.

2.  While pressing the POWER/VOLUME switch, simultaneously press the AUX switch and the RPT/PRESET 1 switch for 2 s or more.

With RDS (radio data system)

am6zzw00005456

Without RDS (radio data system)

am6zzw00005457

Note

•  If several DTCs are in the memory, they can be displayed using the TRACK/SEEK switch (up or down).

3.  To stop the DTC inspection, ignition is switched to off.