CLEARING DTC [AUDIO]

id0902f6855600

Caution

•  Before clearing the DTCs, be sure to enter all of the DTCs displayed in the DTC inspection in the Audio Repair Order Form.

With M-MDS

1.  Connect the M-MDS (IDS) to the DLC-2.

am6zzw00006237

2.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

(1)  Select “Self Test”.

(2)  Select “Modules”.

(3)  Select “ACU”.

3.  Verify the DTC according to the directions on the screen.

4.  Press the clear button on the DTC screen to clear the DTC.

5.  Switch the ignition to off.

6.  Switch the ignition to ON and wait for 5 s or more.

7.  Perform DTC inspection. (See DTC INSPECTION [AUDIO].)

8.  Verify that no DTCs are displayed.

Without M-MDS (On-board Diagnostic Test Mode)

1.  Launch the on-board diagnostic test mode. (See DTC INSPECTION [AUDIO].)

2.  While pressing the POWER/VOLUME switch, simultaneously press the AUDIO CONT switch for 2 s or more.

With RDS (radio data system)

am6zzw00005471

Without RDS (radio data system)

am6zzw00005472

3.  To stop the on-board diagnostic test mode, ignition is switched to off.