No.2 DOOR GLASS DOES NOT OPERATE USING THE KEYLESS TRANSMITTER [POWER WINDOW SYSTEMS (EXTERIOR OPEN/CLOSE FUNCTION)]
id090361808700
|
2
|
Door glass does not operate using the keyless transmitter
|
|
POSSIBLE CAUSE
|
• Any door or liftgate is open
• The key is inserted in the steering lock (Keyless entry system)
• The ignition is switched to position other than off (Advanced keyless entry and push button start system)
• Keyless control module malfunction (Advanced keyless entry and push button start system)
• BCM malfunction
• Open circuit in wiring harness between keyless control module and BCM
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
• Inspect the door lock/unlock operation using the transmitter.
• Does it operate normally?
|
Yes
|
Inspect the following parts, and repair or replace.
• BCM (See BODY CONTROL MODULE (BCM) INSPECTION.)
• Keyless control module (Vehicles with advanced keyless entry and push button start system) (See KEYLESS CONTROL MODULE INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
|
|
No
|
Go to the next step.
|
||
|
2
|
• Inspect the open/close condition of the doors and the liftgate.
• Is the reason why they do not lock/unlock because a door or the trunk lid/liftgate is open?
|
Yes
|
System is normal. (Does not operate when a door or the liftgate is open)
|
|
No
|
Go to the next step.
|
||
|
3
|
• Verify whether the key is in the steering lock. (Keyless entry system)
• Verify that the ignition is switched to a position other than off. (Advanced keyless entry and push button start system)
• Can the doors be locked/unlocked?
|
Yes
|
System is normal (Does not operate when the key is inserted in the steering wheel lock. (Keyless entry system) (Does not operation when the ignition is switched to position other than off. (Advanced keyless entry and push button start system))
|
|
No
|
Go to the next step.
|
||
|
4
|
• When the lock/unlock operation does not operate for reasons other than the above Steps 2 and 3.
|
Yes
|
Inspect the following parts, and repair or replace.
• Keyless control module (See KEYLESS CONTROL MODULE INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM].)
• Wiring harness between keyless control module and BCM.
|
|
No
|
Reinspect for malfunction recurrence. If the malfunction is not corrected, repeat the procedure from Step 1.
|
||