STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]

id0914004395z3

Caution

•  Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:

―  M-MDS

―  Personal computer

―  Devices that can send/receive radio waves

Note

•  The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM])(See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM])

•  For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.

1.  Bring the programmed advanced key into the vehicle.

2.  Fully lower the driver-side door glass.

3.  Connect the M-MDS(IDS) to the DLC-2.

am6zzw00002929

4.  Set the IDS outside the vehicle with its cable passing through the door glass opening.

Caution

•  Cover the vehicle body with a clean rag so as not to damage the vehicle body with the cable.

5.  After the vehicle is identified, select the following items from the initialization screen of the IDS.

(1)  Select “Body”.

(2)  Select “Security”.

(3)  Select “PATS Functions”.

6.  Then, select items from the screen menu in the following order.

(1)  Select “Steering Lock Unit Programming”.

7.  Perform the security access according to the directions on the IDS screen.