|
1
|
INSPECT ELECTRIC PARKING BRAKE SWITCH CONNECTOR CONDITION
• Switch the ignition off.
• Disconnect the negative battery terminal.
• Disconnect the electric parking brake switch connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is the connector normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the connector, then go to Step 5.
|
|
2
|
INSPECT AUTOHOLD SWITCH
• Inspect the AUTO HOLD switch.
• Is the AUTO HOLD switch normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the electric parking brake switch, then go to Step 5.
|
|
3
|
INSPECT ELECTRIC PARKING BRAKE CONTROL MODULE CONNECTOR CONDITION
• Disconnect the electric parking brake control module connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is the connector normal?
|
Yes
|
Go to the next step.
|
|
No
|
Repair or replace the connector, then go to Step 5.
|
|
4
|
INSPECT AUTO HOLD SWITCH CIRCUIT FOR SHORT TO POWER SUPPLY
• Verify that the electric parking brake switch and electric parking brake control module connectors are disconnected.
• Connect the negative battery terminal.
• Switch the ignition ON (engine off or on).
• Measure the voltage at the electric parking brake switch terminal B (wiring harness-side).
• Is the voltage 0 V?
|
Yes
|
Go to the next step.
|
|
No
|
Refer to the wiring diagram and verify whether or not there is a common connector between electric parking brake switch terminal B and electric parking brake control module terminal S.
If there is a common connector:
• Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for a short to power supply.
• Repair or replace the malfunctioning part.
If there is no common connector:
• Repair or replace the wiring harness which has a short to power supply.
Go to the next step.
|
|
5
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Always reconnect all disconnected connectors.
• Connect the negative battery terminal.
• Clear the DTC for the electric parking brake control module using the M-MDS.
• Perform the following procedure 3 times or more.
-
― Presses the AUTO HOLD switch.
― Releases the AUTO HOLD switch.
• Retrieve the electric parking brake control module DTCs using the M-MDS.
• Is the same Pending DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the electric parking brake control module.
Go to the next step.
|
|
No
|
Go to the next step.
|
|
6
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
