DTC U0301:00/U0401:00 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2860500

DTC

U0301:00, U0401:00

Abnormal message from PCM
DETECTION CONDITION
•  Correct data cannot be received from PCM
FAIL-SAFE FUNCTION
•  Refer to “Fail-safe Function Malfunction Contents”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
POSSIBLE CAUSE
•  PCM malfunction
SYSTEM WIRING DIAGRAM
Not applicable


Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY PCM DTC
•  Using the M-MDS, perform the PCM DTC inspection.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))].)
(See DTC TABLE [PCM (SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT CYLINDER DEACTIVATION))].)
(See DTC TABLE [PCM (SKYACTIV-G 2.5T)].)
(See DTC TABLE [PCM (SKYACTIV-D 2.2)].)
DTC troubleshooting completed, then go to the next step
No
Go to the next step.
2
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Using the M-MDS, clear the DTC from the DSC HU/CM.
•  Using the M-MDS, perform the DSC HU/CM DTC inspection.
•  Is the same Pending DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM.
Go to the next step.
No
Go to the next step.
3
VERIFY NO DTC IS PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
No
DTC troubleshooting completed.