DTC B1477:14 [MAZDA ERA-GLONASS CONTROL MODULE]

id0902r6081400

Description

Built-in battery malfunction

Detection condition

The Mazda ERA-GLONASS control module detected an open circuit or a short to ground in the built-in battery circuit.

Fail-safe

Not applicable

Possible cause

•  Built-in battery assembly incorrect

•  Built-in battery connector or terminal malfunction

•  Mazda ERA-GLONASS control module connector or terminal malfunction

•  Built-in battery malfunction

•  Mazda ERA-GLONASS control module malfunction

System wiring diagram

Not applicable

Description	Built-in battery malfunction
Detection condition	The Mazda ERA-GLONASS control module detected an open circuit or a short to ground in the built-in battery circuit.
Fail-safe	Not applicable
Possible cause	• Built-in battery assembly incorrect • Built-in battery connector or terminal malfunction • Mazda ERA-GLONASS control module connector or terminal malfunction • Built-in battery malfunction • Mazda ERA-GLONASS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	INSPECT BUILT-IN BATTERY INSTALLATION CONDITION • Switch the ignition off. • Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.) • Inspect built-in battery installation condition. • Is the built-in battery correctly installed?	Yes	Go to the next step.
1		No	Correctly install the built-in battery, then go to Step 4.
2	INSPECT BUILT-IN BATTERY CONNECTOR CONDITION • Disconnect the built-in battery connector. • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. • Is the connector normal?	Yes	Go to the next step.
2		No	Repair or replace the connector, then go to Step 4.
3	INSPECT MAZDA ERA-GLONASS CONTROL MODULE CONNECTOR CONDITION • Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection. • Is the connector normal?	Yes	Replace the built-in battery, then go to the next step. (See MAZDA ERA-GLONASS CONTROL MODULE BATTERY REMOVAL/INSTALLATION.)
3		No	Repair or replace the connector, then go to the next step.
4	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Always reconnect all disconnected connectors. • Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.) • Clear the DTC for the Mazda ERA-GLONASS control module using the M-MDS. (See CLEARING DTC [MAZDA ERA-GLONASS CONTROL MODULE]) • Switch the ignition ON (engine off or on) and wait for 25 s or more. • Perform the DTC inspection for the Mazda ERA-GLONASS control module using the M-MDS. (See DTC INSPECTION [MAZDA ERA-GLONASS CONTROL MODULE]) • Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the Mazda ERA-GLONASS control module. (See MAZDA ERA-GLONASS CONTROL MODULE REMOVAL/INSTALLATION.) Go to the next step.
4		No	Go to the next step.
5	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [MAZDA ERA-GLONASS CONTROL MODULE])
5		No	DTC troubleshooting completed.