POWER WINDOW SUBSWITCH INSPECTION

id091200002300

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the power window subswitch. (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION.)

3.  Connect the power window subswitch connector.

4.  Connect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

5.  Measure the voltage at each terminal.

•  If the voltage is not as specified in the terminal voltage table, inspect the parts under “Inspection item(s)” and related wiring harnesses.

―  If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch. (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION.)

Terminal voltage table (reference)

ac5jjw00000858

Terminal	Signal name	Connected to	Measurement condition	Voltage (V)	Inspection item (s)
A	Serial communication	Power window main switch	Because this terminal is for communication, good/no good judgment by terminal voltage is not possible		•  Power window subswitch (See POWER WINDOW SUBSWITCH INSPECTION.) •  Related wiring harness
C	Power supply	P.WIND2 25 A fuse	Under any condition	B+	•  P.WIND2 25 A fuse •  Related wiring harness
D	Pulse 2	Power window motor	Door glass operating	Wave pattern (See Inspection Using an Oscilloscope (Reference).)	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness
F	Pulse 1	Power window motor	Door glass operating	Wave pattern (See Inspection Using an Oscilloscope (Reference).)	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness
H	Close output	Power window motor	Door glass closing	B+	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness
			while door glass is closing for approx. 40 s after ignition is switched OFF (LOCK) from ON	B+
			Other	1.0 or less
I	Open output	Power window motor	Door glass opening	B+	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness
			while door glass is opening for approx. 40 s after ignition is switched OFF (LOCK) from ON	B+
			Other	1.0 or less
J	Power supply	Power window motor	Switch the ignition to ACC or ON (engine off)	B+	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness
			Switch the ignition OFF (LOCK)	1.0 or less
K	GND	Body ground	Under any condition:	1.0 or less	•  Related wiring harness
L	Sensor ground	Power window motor	Under any condition:	1.0 or less	•  Power window motor (See POWER WINDOW MOTOR INSPECTION.) •  Related wiring harness

Inspection Using an Oscilloscope (Reference)

am6zzw00009469