REAR SUNSHADE SWITCH INSPECTION

id091200202300

Note

•  The rear sunshade switch is integrated with the cluster switch.

Switch inspection

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

3.  Verify that the resistance between rear sunshade switches A and H is as indicated in the table.

Without parking sensor

am6zzw00014982

With parking sensor

am6zzw00014983

•  If the resistance cannot be verified as indicated in the table, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

LED illumination inspection

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)

3.  Apply battery positive voltage to rear sunshade switch terminal J, and connect terminal I to ground.

aatjjw00009709

4.  Verify that the LED illuminates.

•  If the resistance cannot be verified as indicated in the table, replace the cluster switch. (See CLUSTER SWITCH REMOVAL/INSTALLATION.)