REAR WIPER MOTOR INSPECTION

id091900801500

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the following parts:

(1)  Rear wiper arm and blade (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.)

(2)  Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION.)

(3)  Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION.)

(4)  Liftgate recess (See LIFTGATE RECESS REMOVAL/INSTALLATION.)

(5)  Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION.)

3.  Remove the rear wiper motor connector.

am6zzw00010781

Rear Wiper Motor Operation Inspection

1.  Apply battery positive voltage to rear wiper motor connector terminal B, and connect terminal A to the ground.

2.  Verify that the rear wiper motor operates normally.

am6zzw00017459

•   If there is any malfunction, replace the rear wiper motor. (See REAR WIPER MOTOR REMOVAL/INSTALLATION.)

Auto-stop Operation Inspection

1.  Apply battery positive voltage to rear wiper motor connector terminal B, and connect terminals A and C to the ground.

am6zzw00017460

2.  Disconnect the ground from rear wiper motor connector terminal A while the rear wiper is operating.

3.  After the windshield wiper motor auto-stop operation, verify that it stops at the park position.

am6zzw00017461

•   If there is any malfunction, replace the rear wiper motor. (See REAR WIPER MOTOR REMOVAL/INSTALLATION.)