1. Remove the timing belt. (See TIMING BELT REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
2. Remove in the order shown in the table.
3. Install in the reverse order of removal.
1. Hold the timing belt pulley using the SSTs.
1. Remove the timing belt pulley using the SST.
1. Cut the oil seal lip using a razor knife.
2. Remove the oil seal using a screwdriver protected with a rag.
1. Apply clean engine oil to the oil seal lip.
2. Push the oil seal slightly in by hand.
3. Tap the oil seal in evenly using the SST and a hammer. The oil seal must be tapped in until it is flush with the edge of the oil pump body.
Pushing distance of the front oil seal (from the edge of the oil pump body)
