1. Remove the rear auto leveling sensor.
(See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION [2WD].) (See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION [4WD].)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset.
.
|
1
|
Stabilizer control link
|
|
2
|
Coil spring component (One side only)
|
|
3
|
Stabilizer bracket
|
|
4
|
Bushing
|
|
5
|
Bolt (Differential front side)
|
|
6
|
Rear stabilizer
|
1. Disconnect differential oil temperature sensor connector and 4WD solenoid connector.
2. Support the differential with a jack as shown in the figure.
3. Remove the bolt.
1. Support the differential with a jack, and then install the bolt.
2. Connect differential oil temperature sensor connector and 4WD solenoid connector.
