Diagnostic Procedure
|
Step
|
Inspection
|
Action
|
|
|---|---|---|---|
|
1
|
• Operate the door glass in auto/manual by operating the power window main switch/power window subswitch.
• Does the door glass stop before fully opening/closing using either operation?
|
Yes
|
Inspect the following parts, and repair or replace.
• Power window main switch
• Power window subswitch
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Battery (Low voltage)
• Door glass (Installation condition)
|
|
No
|
Go to the next step.
|
||
|
2
|
• Inspect the operation of the door glass by repeating Step 1 above.
• Does the door glass stop before fully opening/closing while in auto operation?
|
Yes
|
Perform the power window system initial setting procedure.
|
|
No
|
Go to the next step.
|
||
|
3
|
• Open the door glass by operating the transmitter.
• Does the door glass stop before fully opening?
|
Yes
|
Inspect the following parts, and repair or replace.
• Keyless control module (Vehicles with advanced keyless system)
• BCM (See BODY CONTROL MODULE (BCM) INSPECTION.)
|
|
No
|
Go to the next step.
|
||
|
4
|
• Close the door glass by operating the transmitter.
• Does the door glass stop before fully closing?
|
Yes
|
Inspect the following parts, and repair or replace.
• Keyless control module (Vehicle with advanced keyless system)
• BCM (See BODY CONTROL MODULE (BCM) INSPECTION.)
• Keyless entry system signal reception error (outside operation area, radio signal interference)
|
|
No
|
Reinspect for malfunction recurrence.If the malfunction is not corrected, repeat the procedure from Step 1.
|
||