1. Cut away the old sealant using a razor so that 1-2 mm {0.04-0.07 in} thickness of sealant remains around the circumference of the frame.
2. If the sealant has come off completely in any one place, apply some primer after degreasing, and allow it approx. 30 min to dry. Then put on new sealant to create a 2 mm {0.08 in} layer.
3. Clean and degrease an approx. 50.0 mm {1.97 in} wide strip around the circumference of the glass and the bonding area on the body.
4. Install the molding as shown in the figure.
5. Use only glass primer on the glass, and body primer on the body and the molding. Allow it to dry for approx. 30 min.
6. Apply urethane to the area of the glass surface as shown in the figure.
7. Set the position of the front windshield glass and insert a pin into the body. Install the glass.
8. Verify that the gap of the upper part is 7.3 mm {0.29 in} and the A pillar part is 6.8 mm {0.27 in}. (Only for 4SD)
9. Keeping the measurement of the molding lip gap within specification, press completely along the perimeter of the glass.
10. For the 4SD, install the following parts:
11. For the 5HB, install the following points.
12. Allow the sealant to harden completely.
