DTC 12

id0102a0235800

DTC 12

Cruise control switch (RESUME/ACCEL switch)

DETECTION CONDITION

• Resistance detected between cruise actuator connector terminal J and ground is always approximately 2.2 kilohms.

POSSIBLE CAUSE

• Cruise actuator malfunction

Diagnostic procedure

INSPECTION

ACTION

INSPECT DTC FOR OPERATION MODE
• Was operation mode for DTC 22 performed?
Yes
Perform operation mode for DTC 22 on-board diagnostic again. Even if no malfunction is detected in operation mode, if DTC 12 is indicated in condition detection mode on-board diagnostic, replace cruise actuator.
No
Perform operation mode for DTC 22.