DTC 13

id0102a0690300

DTC 13

Cruise control switch (ground circuit)

DETECTION CONDITION

• Resistance detected between cruise actuator connector terminal J and ground is always approximately 0 ohm.

POSSIBLE CAUSE

• Cruise actuator malfunction

Diagnostic procedure

INSPECTION

ACTION

INSPECT DTC FOR OPERATION MODE
• Was operation mode for DTCs 21 and 22 performed?
Yes
Perform operation mode for DTCs 21 and 22 on-board diagnostic again. Even if no malfunction is detected in operation mode, if DTC 13 is indicated in condition detection mode on-board diagnostic, replace cruise actuator.
No
Perform operation mode for DTCs 21 and 22.