DTC P0706 (GENERAL (L.H.D.) SPECS. SPORT AT) [FN4A-EL]

id0502a18009a7

DTC P0706

Transaxle range (TR) switch circuit range/performance

DETECTION CONDITION

• When all conditions below are satisfied and 100 seconds or more have passed.
- Engine speed 530 rpm or above.
- Vehicle speed 20 km/h {12 mph} or above.
- Voltage at TCM terminal 2H is 0.5 V or above.
- P, R, N or D range/position not detected.
Diagnostic support note:
• This is a continuous monitor (CCM).
• MIL illuminates if TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
• PENDING CODE is available if TCM detects the above malfunction condition during first drive cycle.
• FREEZE FRAME DATA is available.
• AT warning light illuminates.
• DTC is stored in the TCM memory.

POSSIBLE CAUSE

• TR switch malfunction.
• TR switch misadjustment.
• TCM malfunction.

Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED

• Has FREEZE FRAME PID DATA been recorded?
Yes
Go to next step.
No
Record FREEZE FRAME PID DATA on repair order, then go to next step.
2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY

• Check for related Service Bulletins availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to available repair information.
• If vehicle is not repaired, go to next step.
No
Go to next step.
3

INSPECT TR SWITCH

• Turn ignition key to OFF.
• Disconnect TR switch connector.
• Inspect for resistance between TR switch terminals B and C (part-side).
• Is resistance okay?
Yes
Go to next step.
No
Adjust TR switch, then go to next step.
4

VERIFY TROUBLESHOOTING OF DTC P0706 COMPLETED

• Make sure to reconnect all disconnected connectors.
• Clear DTC from memory using WDS or equivalent.
• Drive vehicle in each range (D and R) for 100 seconds or more under following conditions.
- Engine speed (RPM PID) 530 rpm or above
- Vehicle speed (VSS PID) 20 km/h {12 mph} or above
• Is pending code present?
Yes
Replace TCM, then go to next step.
No
No concern is detected. Go to next step.
5

VERIFY AFTER REPAIR PROCEDURE

• Perform "After Repair Procedure".
• Are any DTCs present?
Yes
Go to applicable DTC inspection.
No
Troubleshooting completed.