HOLD SWITCH REMOVAL/INSTALLATION (4AT) [FN4A-EL]

1. Disconnect the negative battery cable.

2. Remove the console.

3. Disconnect the connector and remove the HOLD switch terminals. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY (4AT).)

4. Remove the selector lever knob component.

5. Remove the HOLD switch.

6. Install the HOLD switch to selector lever knob component.

7. Install selector lever knob component.

Tightening torque

15.68-22.54 N·m {1.599-2.298 kgf·m, 12-16 ft·lbf}

8. Install the HOLD switch terminals and connect the connector.

9. Install the console.

10. Connect the negative battery cable.