FRONT FENDER PANEL REMOVAL/INSTALLATION

id091000801000

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the following parts:

(1)  Set plate (See SET PLATE REMOVAL/INSTALLATION.)

(2)  Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION.)

(3)  Front combination light (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION.)

(4)  Side step molding (See SIDE STEP MOLDING REMOVAL/INSTALLATION.)

3.  Remove the fasteners.

am6zzw00009426

4.  Remove the front fender up in the direction of the arrow shown in the figure.

5.  Remove bolts.

am6zzw00011283

6.  Remove the front fender panel.

7.  Install in the reverse order of removal.

8.  Adjust the headlight aiming. (See HEADLIGHT AIMING.)

9.  Adjust the front fog light aiming. (with front fog lights) (See FRONT FOG LIGHT AIMING.)