ANTENNA FEEDER NO.3 INSPECTION

id092000813000

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION.)

(2)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(3)  Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

(4)  Tunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(5)  D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Remove the rear passenger's assist handle. (See ASSIST HANDLE REMOVAL/INSTALLATION.)

4.  Partially peel back the headliner.

Note

•  If the headliner is peeled back excessively, the headliner could become creased. Be careful not to peel back the headliner excessively.

5.  Disconnect antenna feeder No.2.

6.  Disconnect the roof antenna connector.

7.  Disconnect the glass antenna connector cover. (With RDS (radio data system)) (See ANTENNA FEEDER NO.3 REMOVAL/INSTALLATION.)

8.  Verify that the continuity between antenna feeder No.3 terminals is as indicated in the table.

Without RDS (radio data system)

am6zzw00010773

With RDS (radio data system)

am6zzw00010774

•  If not as indicated in the table, replace antenna feeder No.3.

Without RDS (radio data system)

am6zzw00010775

With RDS (radio data system)

am6zzw00010776