DTC U3000:41 [L8, LF, L5]
id010242851600
DTC U3000:41 |
PCM processor |
---|---|
DETECTION CONDITION
|
• PCM internal EEPROM malfunction.
Diagnostic support note
• This is a continuous monitor (Other).
• The MIL does not illuminate
• FREEZE FRAME DATA is not available.
|
POSSIBLE CAUSE
|
• PCM internal malfunction
|
Diagnostic procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY TROUBLESHOOTING OF DTC U3000:41 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOEO self test.
• Is the same DTC or PENDING CODE present?
|
Yes
|
Replace the PCM, then go to the next step.
|
No
|
Go to the next step.
|
||
4
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [L8, LF, L5].)
|
No
|
DTC troubleshooting completed.
|