DTC P1675:00 [MZR-CD (RF Turbo)]
id0102f1149800
|
DTC P1675:00 |
Injector data not programmed |
|---|---|
|
DETECTION CONDITION
|
• The fuel injector code program configuration error
Diagnostic support note
• The MIL illuminates if the PCM detects the above malfunction condition in first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
|
|
POSSIBLE CAUSE
|
• Fuel injector code program input procedure does not been completed.
• PCM malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
• Has FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
|
2
|
VERIFY RELATED SERVICE INFORMATION
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to available Service Information.
• If vehicle is not repaired, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY FUEL INJECTOR COMPENSATION DATA INPUT PROCEDURE
• Does the fuel injector code program input procedure properly?
|
Yes
|
Go to the next step.
|
|
No
|
Perform the fuel injector code program input procedure.
|
||
|
4
|
VERIFY TROUBLESHOOTING OF DTC P1675:00 COMPLETED
• Make sure to reconnect all disconnected connectors.
• Switch the ignition to ON (engine off).
• Clear the DTC from PCM memory using the M-MDS.
• Start the engine.
• Is the same DTC present?
|
Yes
|
Replace the PCM, go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY AFTER REPAIR PROCEDURE
• Perform “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
Troubleshooting completed.
|
||