NO.5 DSC*2 OPERATES FREQUENTLY/DSC DOES NOT WORK CORRECTLY *2: DSC INDICATOR LIGHT GOES ON AND OFF WHILE DSC OPERATES [DYNAMIC STABILITY CONTROL (DSC)]

NO.5 DSC^*2 OPERATES FREQUENTLY/DSC DOES NOT WORK CORRECTLY ^*2: DSC INDICATOR LIGHT GOES ON AND OFF WHILE DSC OPERATES [DYNAMIC STABILITY CONTROL (DSC)]

id0403b2880200

5

DSC (*2) operates frequently. /DSC does not work correctly.

(*2): DSC indicator light goes on and off while DSC operates.

[TROUBLESHOOTING HINTS]

•  DSC HU/CM detected malfunction (input and output device malfunction)

•  Poor installation with combined sensor and/or steering angle sensor
(If any of the above sensors are poorly installed, DSC may operate intermittently)

•  When replacing DSC HU/CM or steering angle sensor initialization is not performed
(If initialization is not performed correctly, DSC may not work correctly)

Diagnostic procedure

STEP	INSPECTION		ACTION
1	CONFIRM DSC HU/CM DTC • Retrieve DSC HU/CM DTC using the M-MDS. • Is there any DTC retrieved?	Yes	Go to the applicable DTC troubleshooting procedure. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)].)
1		No	Go to the next step.
2	VERIFY THAT EACH SENSOR IS INSTALLED • Are combined sensor and steering angle sensor securely installed?	Yes	Go to the next step.
2		No	Install malfunctioning sensor securely.
3	VERIFY THAT EACH SENSOR IS INITIALIZED • Did each sensor initialize after replacement of DTC HU/CM or steering angle sensor?	Yes	Find malfunctioning part according to “INTERMITTENT CONCERN TROUBLESHOOTING.”
3		No	Perform initialization procedure.