SHIFT-LOCK SOLENOID INSPECTION

id051800802200

1.  Disconnect the negative battery cable.

2.  Remove the rear console. (See REAR CONSOLE REMOVAL/INSTALLATION.)

3.  Connect the negative battery cable.

4.  According to the table, measure the voltage between selector lever component terminals and body GND.

am6zzw00002914

•  If there is any malfunction, replace the related wiring harness.

•  If there is no malfunction, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

Terminal	Connected to	Test condition	Voltage (V)
E	Brake switch	Brake pedal depressed	B+
		Brake pedal released	Below 1.0
I	Ignition (power supply)	Switch the ignition to ACC or ON	B+
		Switch the ignition to OFF	Below 1.0
K	Body GND	Under any conditions	Below 1.0