 |
am6zzw00001931
POWER WINDOW SUBSWITCH INSPECTION
id091200802200
1. Disconnect the negative battery cable.
2. Remove the inner garnish. (front passenger’s side)(See INNER GARNISH REMOVAL/INSTALLATION.)
3. Remove the front door trim. (front passenger’s side)(See FRONT DOOR TRIM REMOVAL/INSTALLATION.)
4. Remove the rear door trim. (rear side)(See FRONT DOOR TRIM REMOVAL/INSTALLATION.)
5. Connect the negative battery cable.
6. Measure the voltage at each terminal (other than terminals C and D).
7. Inspect the power window subswitch connector for continuity at terminals C and D.
8. If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.
am6zzw00001931
|
|
Terminal |
Signal name |
Connected to |
Measured condition |
Voltage (V)/Continuity |
Inspection item (s) |
|---|---|---|---|---|---|
|
C
|
GND
|
Body ground
|
Under any condition:
|
1.0 or less
|
• GND
|
|
D
|
Sensor ground
|
Power window motor
|
Under any condition:
|
1.0 or less
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
E
|
Pulse 2
|
Power window motor
|
Door glass moving
|
Alternates between 1.0 or less and B+
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
Door glass stopped
|
1.0 or less or B+
|
||||
|
F
|
Open output
|
Power window motor
|
While door glass is opening
|
B+
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
G
|
Power supply
|
Power window motor (driver’s side)
|
Ignition switch at ON
|
B+
|
• Power window motor (driver’s side)(See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harness
|
|
H
|
Close output
|
Power window motor
|
While door glass is opening
|
1.0 or less
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
While door glass is closing
|
B+
|
||||
|
I
|
Pulse 2
|
Power window motor (driver’s side)
|
Door glass (driver’s side) operating
|
12 or less
|
• Power window motor (driver’s side)(See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harness
|
|
J
|
Power supply
|
P/W 30 A fuse
|
Ignition switch at ON
|
B+
|
• P/W 30 A fuse
• Related wiring harness
|
|
K
|
Communication
|
Power window main switch
|
Because this terminal is for communication, good/no good judgment by terminal voltage is not possible
|
B+
|
• Power window subswitch (See POWER WINDOW SUBSWITCH INSPECTION.)
• Related wiring harness
|
|
L
|
Power-cut signal
|
Power window subswitch
|
Ignition switch at ON and power-cut switch at UNLOCK
|
B+
|
• Power window subswitch (See POWER WINDOW SUBSWITCH INSPECTION.)
• Related wiring harness
|